Sandblasting and surface preparation
Sandblasting to prep steel and fabricated work for coating — part of OTEK's in-house finishing capability.
- Surface preparation
- Ready for coating
- In-house with spray painting
What's included
Surface prep that sets up a lasting coat
Sandblasting at OTEK prepares steel and fabricated work so coatings bond properly — rust, scale, old paint and surface contamination stripped back so protective or finishing coats have a clean, consistent base. It’s part of our in-house finishing capability, not a bolt-on from another yard.
We blast work fabricated here and items brought in for prep ahead of spray painting. Keeping blast and paint under one roof means less cartage, fewer handovers, and a clearer finish path for plant, pipework, frames and general steel Australia-wide.
Tell us what you’re blasting — size, condition, and whether it needs paint after. We’ll confirm scope, quote the prep (and coating if required), then move straight into spray painting when the job calls for a finished, protected surface.
How blast jobs usually run
Confirm the item/scope → quote → blast → paint if required.
Tell us what you need
Call or send a short note about the weld, fab or finishing job.
Get a clear quote
We'll confirm scope and next steps before work is booked.
We complete the work
Workshop or onsite — including blast and paint when required.
You're looked after
Questions after the job are welcome — call 0428 882 072.
Sandblasting FAQs
Questions about sandblasting? Call 0428 882 072 or request a quote. Browse our Mildura, Wentworth, Renmark, Broken Hill and Swan Hill area pages for local coverage.
Sandblasting across our service areas
Victoria, NSW and South Australia from our Mildura base — open an area page for local coverage.
Mildura
Home base
Local Mildura welding and engineering for farms, industry and contractors
